Calvalley Petroleum IncTSX: CVI.A

Calvalley Petroleum Tests Hiswah-4 Appraisal Well

· Issued by Calvalley Petroleum Inc
Symbol (shares): CVI.A
Shares Outstanding: 83,595,597
Symbol (warrants): CVI.WT
Warrants Outstanding: 5,233,614

CALGARY, AB, April 11 /CNW TELBEC/ - Calvalley Petroleum Inc. - Calvalley
Petroleum, Operator of Block 9 in the Republic of Yemen, is pleased to
announce the testing of a horizontal appraisal well, drilled into the Hiswah
oil discovery that confirms a continuous oil reservoir over the 7 km long
structure.
The Hiswah-4 well was drilled with a vertical wellbore to a depth of
1276 metres in order to evaluate the oil-bearing Saar Formation. This vertical
hole was used to gather reservoir data including two separate 9 metre cores.
Independent petrophysical analysis has determined that Hiswah-4 intersected
approximately 60 metres of gross 35 degrees API gravity oil pay and 20 metres
of gross natural gas pay, over a total 80 metre gross interval, with average
porosity of 16 percent. Cores cut from the Saar oil column show good oil
staining within micro-fractured, high-energy carbonate grainstones which were
comparable to the Hiswah-3 reservoir.
Hiswah-4 production tests were conducted over the open hole, horizontal
well section with an electric submersible pump which cleaned the well up
quickly and established flow rates of up to 1,200 barrels of oil per day and
400 Mcf per day of natural gas over several hours. The test was terminated
when the pump failed due to a contractor's surface electrical control panel
failure. Subsequent to termination of the test, oil continued to flow without
artificial lift, at rates of up to 1,098 barrels oil per day before the well
was successfully controlled by injecting 1,100 barrels of kill fluid into the
well bore, then the downhole equipment was retrieved.
The test was then continued using a different contractor with new
downhole and surface equipment. During the clean-up only 20% of the kill fluid
was recovered and the well flowed at a reduced sustained flow rate averaging
380 barrels of oil per day and 600 Mcf per day of natural gas with no
formation water, for 48 hours. Preliminary evaluation indicates that the
reduced flow rate may be due to well bore damage which occurred between the
time the kill fluid was injected and removal of the downhole equipment at the
end of the initial test period. Upon completion of the evaluation, remedial
workover operations will follow to rectify the damage and prepare the well for
future production.
The production test and geological reservoir data at Hiswah-4 confirms
that the reservoir is a contiguous, single oil accumulation. Hiswah-4 is the
second of several horizontal appraisal wells planned for the Hiswah oil pool.
The drilling rig is currently being moved to the Hiswah-5 well location,
approximately 700 meters northwest of the Hiswah-4 well.

The TSX Venture Exchange does not accept responsibility for the adequacy
or accuracy of this news release.

This Press Release contains certain information that may constitute
forward-looking statements under applicable securities laws. These statements
are subject to unknown risks and uncertainties that could cause actual results
to differ materially from those anticipated or implied in the forward-looking
statements.
%SEDAR: 00001745E

Calvalley Petroleum Inc on 6ix

Later from Calvalley Petroleum

All Calvalley Petroleum news releases