Compagnie de Saint-Gobain SA · EURONEXT:SGO
Compagnie de Saint-Gobain SA — Saint-Gobain — Technical Presentation (September 2001)
7 slides from Compagnie de Saint-Gobain SA's technical presentation, Sep 26, 2001
Slide 1: 1A8 Diamond Dicing Blade Mounting Procedure
1A8 Diamond Dicing Blade Mounting Procedure Christophe Oliver – September 26, 2001
Slide 2: A. Assembly components
A. Assembly components 1. Diamond blade (left) 2. Same with flange top Flange (center) and bottom separated Dismounting tool (right) (center)
Slide 3: B. Removing blade from case
B. Removing blade from case 3. Lightly press case center 4. Lift case top once loosened. while holding periphery. 5. Gently turn case over. 6. Place blade onto flat hand.
Slide 4: C. Placing blade on flange bottom
C. Placing blade on flange bottom 7. Bring blade to finger tips. 8. Place blade carefully at 9. Adjust blade into position center of flange bottom. with finger tip if needed.
Slide 5: D. Final assembly
D. Final assembly 10. Pick up flange top. 11. Place flange top into position and press down firmly. 12. Slide assembly to table 13. Assembly is ready to dice. edge and pick up carefully.
Slide 6: E. Dismounting steps
E. Dismounting steps 14. Align dismounting tool 15. Insert dismounting 16. Turn assembly over. with holes on back side. tool in holes. 17. Press gently at center 18. Remove flange top. 19. Remove used blade with thumbs to dismount and dismounting tool. assembly.
Slide 7: Contact information
Contact information Gerry Kayer Customer Service Representative, Electronics Saint-Gobain Abrasives / Norton 1 New Bond Street Mail-Stop 419-201 Worcester, MA 01615-0008 - U.S.A. 1(508)795-5973 Direct phone 1(800)424-0800 Phone 1(508)795-5660 Direct fax 1(800)336-9595 Fax 1(888)969-5795 Pager gerard
Saint-Gobain — Technical Presentation (September 2001) on 6ix