Press release
SiPM dToF LiDAR Platform from ON Semiconductor Provides Ready-to-Use Design for Industrial Range Finding Applications
The platform showcases direct Time-of-Flight LiDAR using ON Semiconductor's Silicon Photomultiplier (SiPM) sensor expertise PHOENIX--(BUSINESS WIRE)-- ON
About this update from On Semiconductor Corporation
[{"type":"text","content":"\nThe platform showcases direct Time-of-Flight LiDAR using ON Semiconductor's Silicon Photomultiplier (SiPM) sensor expertise \n\n PHOENIX--(BUSINESS WIRE)--\nON Semiconductor (Nasdaq:ON), driving energy efficient innovations, has introduced a single point direct Time-of-Flight (dToF) LiDAR solution enabled by the company's Silicon Photomultiplier (SiPM) technology.\n\nThe application of light detection and ranging, or LiDAR, is growing across all sectors, including robotics and industrial proximity sensing where millimetre range accuracy is mandatory. It is typically based upon the dToF method, which measures the time it takes for a pulse of light, normally in the Near Infrared (NIR) wavelength range, to travel to and from an object.\n\nWhile the principle is simple, its application can pose challenges, for example, environmental factors such as high levels of ambient solar light. To determine range accurately, the receiver needs to capture as much of the signal as possible. Traditional photodiodes suffer here, in terms of response time and sensitivity. The Silicon Photomultiplier (SiPM) sensor, developed by ON Semiconductor, overcomes these shortfalls by providing faster response times and high detection efficiency. The reference platform uses the RB-Series, ON Semiconductor's second generation of SiPM sensors, which deliver improved performance in red and the NIR range.\n\nThe SiPM dToF LiDAR Platform developed by ON Semiconductor provides a complete solution for low cost, single point LiDAR that OEMs can adapt and take into production to create industrial range finding applications. It includes the NIR laser diode, SiPM sensor and optics, as well as the digital processing necessary to convert the detected signals into elapsed time, and elapsed time into distance.\n\nTo accelerate customers' time to market, ON Semiconductor has made all of the design data for the reference platform available, covering the schematics, BoM, gerber files, and PCB design files. A PC-based GUI is also accessible, which provides a graphical representation of the measurements over time. The histograms generated provide further evidence of the system's capabilities in applications such as range finding, collision detection and 3D mapping.\n\n“Range finding using dToF LiDAR delivers on a critical need for many applications, extending from autonomous n...